I recommend that if you're about to do any such manual compilation, you first change your PATH in that terminal so it only references at most one of MacPorts and Fink. Usually that works ok, sometimes it doesn't, sometimes it mysteriously breaks later on. Does your friend compile other Unixy software manually, outside of Fink and MacPorts? It's possible that those programs will end up dynamically linking against a combination of Fink and MacPorts libraries. Oh, one more little thing that can cause trouble. This is the simplest installation procedure that most. Maxime -bash: deluged-2.7: command not found macports -bash: macports: command not found I cant seem to get anything running at all. To install MacPorts from the source code, follow the steps below. MacPorts version 2.7.2 is available in various formats for download and installation (note, if you are upgrading to a new major release of macOS, see the migration info page ): pkg installers for Monterey, Big Sur, and Catalina for use with the macOS Installer. I also tried installing it the macport way, but all i get from my terminal is : Code: Select all. Then you could put a symlink to /sw/bin/qemu in there, to ensure it will take priority over the MacPorts version. If you installed MacPorts using the package installer, skip this section. In these cases, I find it helpful to make a directory in $HOME/bin, and put it at the front of your PATH. Eg: If the MacPorts version of qemu has a bug, and you need to make sure you only run the Fink version. The only time it's important is if you want to run some program from one distribution and not the other. Most of the time, even the PATH concerns don't matter much. As others have mentioned, homebrew is quite a bit less careful about this. They're both pretty careful not to interfere with the other. Fink will (by default) install in /sw, and MacPorts in /opt/local, though it's possible to change those. There's no problem at all installing both Fink and MacPorts at the same time, I have them both installed right now. Best answer: Hi, I'm one of the project leads for Fink.
0 Comments
Leave a Reply. |